| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_hashlimit: validate hashtable supports XT_HASHLIMIT_RATE_MATCH
The XT_HASHLIMIT_RATE_MATCH flag mode changes the semantics of the
dsthash_ent structure which represents an entry in the hashtable. There
is a union area which uses a different layout to express the rate match
mode.
Update .checkentry path to validate the XT_HASHLIMIT_RATE_MATCH mode
flag is requested by two or more different rules that refer to the same
hashtable. Otherwise, uninitialized access to the burst field in the
union is possible.
Reject the use of the XT_HASHLIMIT_RATE_MATCH mode flag if set on by
revision less than 3 too. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: SVM: Update x2APIC MSR intercepts if AVIC is inhibited while L2 is active
Always update x2APIC MSR intercepts for L1 when AVIC is deactivated, even
if L2 is active and KVM is using a separate MSR bitmap to run L2. If AVIC
is fully enabled prior to running L2, and is then inhibited while L2 is
active (for a VM-scoped inhibit), then KVM will run L1 with AVIC disabled,
but with x2APIC MSR intercepts disabled, i.e. will allow L1 to read most of
the host's APIC state, send arbitrary interrupts, change task priority, and
ultimately trivially DoS the host.
E.g. sending a self-IPI in L1 on HYPERV_REENLIGHTENMENT_VECTOR, 0xee, with
CONFIG_HYPERV=n in the host kernel as a "safe" PoC, yields:
Spurious interrupt (vector 0xee) on CPU#425. Acked
And hacking KVM to abuse kvm_set_posted_intr_wakeup_handler() to register a
handler and WARN on POSTED_INTR_WAKEUP_VECTOR yields:
------------[ cut here ]------------
WARNING: arch/x86/kvm/svm/svm.c:5594 at pi_wakeup_handler+0x9/0x10 [kvm_amd], CPU#156: nested_x2apic_t/316940
CPU: 156 UID: 0 PID: 316940 Comm: nested_x2apic_t Tainted: G S U
Tainted: [S]=CPU_OUT_OF_SPEC, [U]=USER
Hardware name: Google Astoria-Turin/astoria, BIOS 0.20260209.0-0 02/09/2026
RIP: 0010:pi_wakeup_handler+0x9/0x10 [kvm_amd]
Call Trace:
<IRQ>
sysvec_kvm_posted_intr_wakeup_ipi+0x64/0x80
</IRQ>
<TASK>
asm_sysvec_kvm_posted_intr_wakeup_ipi+0x1a/0x20
RIP: 0010:vcpu_run+0x1430/0x1e40 [kvm]
kvm_arch_vcpu_ioctl_run+0x2c1/0x600 [kvm]
kvm_vcpu_ioctl+0x580/0x6b0 [kvm]
__se_sys_ioctl+0x6d/0xb0
do_syscall_64+0x10a/0x480
entry_SYSCALL_64_after_hwframe+0x4b/0x53
RIP: 0033:0x46ff4b
</TASK>
---[ end trace 0000000000000000 ]--- |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: rtw89: fix wrong pci_get_drvdata type in AER handlers
rtw89 stores an ieee80211_hw pointer via pci_set_drvdata() at probe
time, but io_error_detected() and io_resume() retrieve it as a
net_device pointer. This causes netif_device_detach/attach to
operate on an ieee80211_hw struct, reading and writing at wrong
offsets. The adjacent io_slot_reset() already does it correctly.
Use ieee80211_stop_queues/wake_queues instead, consistent with
every other queue stop/start path in the driver.
Tested on RTL8852CE by calling the handlers from a test module
before and after the fix. |
| Open Zaak is an open-source data and services layer for Dutch case-oriented working. From 1.13.0 until 1.27.2, 1.28.2, and 1.29.0, _import_document_row in src/openzaak/components/documenten/tasks.py uses the attacker-controlled bestandspad CSV field without ensuring that the resolved path remains under IMPORT_DOCUMENTEN_BASE_DIR. A client with an all-authorizations application token can supply an absolute or parent-traversal path to a file readable by the Celery service account. The worker copies that file into document storage, allowing its contents to be retrieved through the normal document download API and exposing server secrets or other private files. This issue is fixed in versions 1.27.2, 1.28.2, and 1.29.0. |
| The Visual Form Builder WordPress plugin through 3.1 does not perform an authorization check before displaying recent form submission data in a dashboard widget, allowing any authenticated user (Subscriber and above) to read other users' submitted contact information, including names, email addresses, form titles and timestamps. |
| The Product Delivery Date for WooCommerce WordPress plugin before 3.3.2 does not perform a capability check before disclosing order details through its calendar view AJAX actions, allowing users with a role as low as Contributor to view other customers' order information. |
| Heap-based buffer overflow in Microsoft Office Excel allows an unauthorized attacker to execute code over a network. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: fsl: fsl_audmix: Validate written enum values
fsl_audmix_put_mix_clk_src() and fsl_audmix_put_out_src()
convert the user-provided enum item with snd_soc_enum_item_to_val()
before checking whether the item is within the enum's item count.
The generic snd_soc_put_enum_double() helper performs that
validation, but these callbacks use the converted value first: the
clock-source path tests it with BIT(), and the output-source path
indexes the prms transition table with it.
Reject out-of-range enum items before converting them. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_u32: reject invalid shift counts
u32_match_it() executes rule-supplied shift operands on a 32-bit
value. A malformed u32 rule can provide a shift count of 32 or more,
triggering an undefined shift out-of-bounds during packet evaluation.
Validate XT_U32_LEFTSH and XT_U32_RIGHTSH operands in
u32_mt_checkentry() and reject malformed rules before they reach the
packet path. |
| In the Linux kernel, the following vulnerability has been resolved:
cifs: validate DFS referral string offsets
parse_dfs_referrals() validates that the response header and referral
array fit in the received buffer, but each referral also contains string
offsets supplied by the server.
Those offsets are used to compute the DfsPath and NetworkAddress string
pointers without checking whether they still point inside the response
buffer. A malformed referral can therefore make the computed pointer
exceed the end of the buffer. The resulting negative max_len is then
passed to cifs_strndup_from_utf16(), and the non-Unicode path forwards it
to kstrndup() as a size_t, allowing strnlen() to read out of bounds.
Validate each string offset before deriving the string pointer. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: SOF: ipc4-control: Validate notification payload size
Validate MODULE_NOTIFICATION payload length before reading
bytes/channel data in control update handling. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: SOF: ipc3-control: Fix heap overflow in bytes_ext put/get
The ipc_control_data buffer is allocated as kzalloc(max_size), where
max_size covers the entire struct sof_ipc_ctrl_data including its
flexible array payload. However, the bounds checks in bytes_ext_put
and _bytes_ext_get compared user data lengths against max_size
directly, ignoring that cdata->data sits at an offset of
sizeof(struct sof_ipc_ctrl_data) bytes into the allocation.
This allowed writing up to sizeof(struct sof_ipc_ctrl_data) bytes past
the end of the heap buffer from unprivileged userspace via the ALSA TLV
kcontrol interface, and similarly allowed over-reading adjacent heap
data on the get path.
Fix all bounds checks to subtract sizeof(*cdata) from max_size so they
reflect the actual space available at the cdata->data offset. Also fix
the error-path restore in bytes_ext_put which wrote to cdata->data
instead of cdata, causing the same overflow. |
| In the Linux kernel, the following vulnerability has been resolved:
can: bcm: extend bcm_tx_lock usage for data and timer updates
Stage new CAN frame content for an existing tx op into a kmalloc()'d
buffer and validate it there, mirroring the approach already used in
bcm_rx_setup(). Only copy the validated data into op->frames while
holding op->bcm_tx_lock, so bcm_can_tx() and bcm_tx_timeout_handler()
can no longer observe a partially updated or unvalidated frame.
Add a missing error path for memcpy_from_msg() when copying CAN frame
data from userspace.
Also move the kt_ival1/kt_ival2/ival1/ival2 updates in bcm_tx_setup()
under op->bcm_tx_lock, and read kt_ival1/kt_ival2/count under the same
lock in bcm_tx_set_expiry() and bcm_tx_timeout_handler(), closing the
torn 64-bit ktime_t read on 32-bit platforms. |
| FreeRDP from 3.30.0 before 3.32.0 contains a resource exhaustion vulnerability in the rdpecam client that lets malicious RDP servers request unadvertised camera media types. Attackers can send a StartStreamsRequest with oversized dimensions to force large pending-sample allocations and reconfigure the local camera through the HAL. |
| FreePBX is an open source IP PBX. Prior to versions 16.0.40 and 17.0.7, a critical remote code execution (RCE) vulnerability exists in the superfecta module due to unsafe inclusion of arbitrary PHP files, allowing authenticated attackers to execute arbitrary PHP code on the server with the privileges of the web server user. Authentication with a known username is required. The vulnerability is rooted in the options and save_options cases in the Superfecta module's AJAX handler. The code dynamically includes PHP files from the sources/ directory based on user-supplied input. This allows an attacker to execute arbitrary code when combined with arbitrary directory creation (e.g., via the backup module) and file uploads that reveal full paths (e.g., via the soundlang module). This issue has been patched in versions 16.0.40 and 17.0.7. |
| In Apache CXF, the parser for multipart/MTOM attachment part headers did not fully enforce the configured attachment-max-header-size (default 300 characters) and attachment-headers-max-count (default 500) limits. The size limit was applied only to each physical line, not to a header value built from continuation lines or to the combined values of a repeated header. The count limit was checked against the number of distinct header names, not the total number of header lines. A remote, unauthenticated attacker could send a multipart request with very large folded or repeated part headers. The server would then allocate memory without bound, causing a denial of service.
Users are recommended to upgrade to versions 4.2.4 or 4.1.9 or 3.6.13, which fix this issue. |
| Improper access control in Samsung Internet prior to version 30.0.5.6 allows local attackers to access sensitive information. |
| Path traversal in Samsung Flow prior to version 4.9.22.1 allows local attackers to access clipboard data. |
| Generation of Error Message Containing Sensitive Information vulnerability in ash-project ash_typescript allows an unauthenticated attacker to read internal Elixir terms from an RPC error response by provoking an error the error builder has no dedicated clause for.
AshTypescript.Rpc.ErrorBuilder.build_error_response/1 in lib/ash_typescript/rpc/error_builder.ex renders a pipeline error term that matches no specific clause with inspect/1 and places the result in details.error of the client-facing error. Ash exceptions take a separate path in AshTypescript.Rpc.Errors where unhandled cases are redacted behind an errorId, but these fallbacks have no redaction, so whatever the term carries reaches the HTTP or channel response. Two request paths hand it such terms: a struct-typed action argument with an invalid nested value, where cast_map_to_struct/2 in lib/ash_typescript/rpc/input_formatter.ex throws the raw Ash.Type cast error into the builder, and field selection on a generic action that returns a primitive, where format_field_type/1 inspects the full Ash.Info.Manifest.Type struct into vars.returnType. Resource module names in vars.resource are not treated as sensitive and are out of scope.
This issue affects ash_typescript: from 0.1.0 before 0.19.1. |
| In the kernel apsys DVFS driver, there is a possible out-of-bounds read or hardware register corruption due to improper input validation of the frequency index. This could lead to system instability or denial of service with local privileges. |
