| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Out-of-bounds write in .NET allows an unauthorized attacker to execute code over a network. |
| Out-of-bounds write in .NET allows an unauthorized attacker to execute code over a network. |
| Out-of-bounds write in .NET Framework allows an unauthorized attacker to execute code over a network. |
| A flaw was found in gst-plugins-base. A heap buffer overflow can be triggered when processing video buffers whose attached GstVideoMeta metadata declares plane strides and offsets that exceed the actual backing memory allocation. The metadata is not range-checked during deserialization, and the video frame mapping code does not verify that the declared plane geometry fits within the buffer before allowing consumers to read or write video data. A local attacker who controls the sending side of a GStreamer inter-process IPC pipeline can deliver a crafted buffer carrying fabricated strides, causing the receiving process to read or write beyond heap boundaries. Successful exploitation can cause a denial of service or potentially allow code execution within the affected process. |
| A flaw was found in GStreamer's H.266 codec parser library (libgstcodecparsers). An out-of-bounds write vulnerability exists in the DCI parsing function, where a reserved field value is incorrectly accepted, causing the parser to write beyond the bounds of an internal structure. An attacker could exploit this by providing a specially crafted H.266 bitstream to a third-party application that uses this library API, potentially causing a crash or memory corruption. No standard GStreamer pipeline element currently invokes the affected code path. |
| SOEM version 2.0.0 and earlier contains vulnerabilities where a malicious device on the network can send specially crafted messages that cause the master to write data outside allocated memory boundaries. The software performs arithmetic on message length values without proper validation, allowing negative or extremely large values to bypass safety checks. This can corrupt memory and potentially allow an attacker to execute arbitrary code on the master system. |
| An out-of-bounds write vulnerability in the Qt Framework assimp scene import plugin of the Qt3D module. |
| Due to a Memory Corruption vulnerability in Application Server ABAP for SAP NetWeaver and ABAP Platform, an unauthenticated attacker could send specially crafted requests to the application. If processed by the application, these requests could trigger a memory corruption condition in the parsing routine, which could cause the affected processes to crash and restart. By repeatedly sending such requests, the attacker could cause a sustained denial of service, leading to a high impact on availability. Confidentiality and integrity remain unaffected. |
| A buffer overflow when handling pointer barriers in the XFIXES extension in X.Org X server before 21.1.25 and XWayland before 24.1.14 could be used by authenticated X clients to crash or potentially execute code in X server context. |
| A buffer overflow in RandR
ChangeProviderProperty requests in X.Org X Server before 2.1.25 and XWayland before 24.4.14 could be used by authenticated X clients to crash or execute code within the X server context. |
| Out-of-Bounds Write Vulnerability in Hitachi Dynamic Link Manager for Linux.
This issue affects Hitachi Dynamic Link Manager for Linux: from 7.5.0-00 before 9.0.5-00. |
| An
out-of-bounds write in certain ASUS Router firmware
allows an unauthenticated nearby user to send an HTTP request containing
parameters that exceed the buffer length, potentially overwriting other memory
regions or causing the system to crash.
Refer to the ' Security Update for ASUS Router Firmware ' section on the ASUS Security Advisory for more information. |
| SAP NetWeaver (Internet Graphics Service) does not sufficiently validate certain input values within incoming requests. An unauthenticated user could send a specially crafted request to trigger an out-of-bounds memory write in a worker process. Successful exploitation could result in memory corruption or repeated termination of the affected process, resulting in a high impact on availability and a low impact on integrity with no impact on confidentiality. |
| The NXP ENET-QOS Ethernet driver's receive work handler eth_nxp_enet_qos_rx() in drivers/ethernet/eth_nxp_enet_qos hands each processed descriptor back to the DMA by writing desc->read.control = rx_desc_refresh_flags, which sets OWN_FLAG and BUF1_ADDR_VALID_FLAG. RDES0 of a receive descriptor is the DMA buffer address in read format, but the hardware write-back aliases that word with the VLAN tag fields (or, for a context descriptor, the timestamp low word), so it is destroyed on every completion. The success path rewrites desc->read.buf1_addr before re-arming; the four drop paths — errored or non-first descriptor, net_pkt_rx_alloc() failure, invalid descriptor length, and net_pkt_get_frag() failure — did not, re-arming the ring slot with the write-back residue as its DMA target address.
The drop paths are driven entirely by received traffic and need no privilege or special configuration. With the defaults for this driver (CONFIG_NET_BUF_DATA_SIZE of 128 and 16 receive descriptors) a single full-size frame consumes twelve ring slots and twelve K_NO_WAIT fragment allocations, so a short burst of frames sent to the device exhausts the receive pools and reaches the allocation-failure paths; a frame with a receive error, or any frame whose first descriptor was already dropped, reaches the non-first-descriptor path.
Once a slot has been poisoned, the DMA writes the next frame received in that slot to an address derived from the frame's VLAN tag fields rather than to a receive buffer. On the supported MCX SoCs that address falls in flash or reserved space, so the transfer raises a fatal bus error that the driver only logs — there is no reset or recovery path — and reception stops permanently until the device is rebooted; where the write is silently discarded instead, the untouched buffer is later handed to the network stack with a length, delivering stale buffer contents as if they were a received frame. A single triggering event is enough to make the condition persistent, so an attacker able to send traffic to the device can permanently disable its network interface. |
| ModSecurity is an open source, cross platform web application firewall (WAF) engine for Apache, IIS and Nginx. From 3.0.15 until 3.0.17, XML request body processing with SecParseXmlIntoArgs set to On or OnlyArgs can leave XMLNodes::parsing_ctx_arg uninitialized in the SAX end-element callback. A single crafted unauthenticated HTTP request can make a worker dereference the pointer, resulting in a constant-value write to an attacker-controlled address. The resulting memory corruption can terminate the worker and may disclose memory or redirect execution. Earlier 3.0.x releases and ModSecurity 2.x do not use the affected path. This issue is fixed in version 3.0.17. |
| Bridge is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| Bridge is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| A flaw was found in OpenSCAP. A heap-based buffer overflow can occur when processing a specially crafted Extensible Configuration Checklist Description Format (XCCDF) document using the sds-compose option. An attacker could exploit this vulnerability to corrupt memory, resulting in an application crash and a Denial of Service (DoS). |
| TinyUSB through 0.21.0, fixed in commit e85c2b8, contains an out-of-bounds write vulnerability in the MTP device class helper mtp_container_get_string() in src/class/mtp/mtp.h that allows a malicious USB host to corrupt adjacent memory by supplying a crafted MTP string with an unbounded character count. Attackers can exploit the unchecked memcpy operation copying up to 510 bytes into a fixed-size destination buffer to achieve code execution or cause a denial of service on the TinyUSB MTP device. |
| Issue summary: An application trying to decrypt CMS messages encrypted using
password based encryption can trigger an out-of-bounds read and write.
Impact summary: This out-of-bounds read may trigger a crash which leads to
Denial of Service for an application. The out-of-bounds write can cause
a memory corruption which can have various consequences including
a Denial of Service or Execution of attacker-supplied code.
Although the consequences of a successful exploit of this vulnerability
could be severe, the probability that the attacker would be able to
perform it is low. Besides, password based (PWRI) encryption support in CMS
messages is very rarely used. For that reason the issue was assessed as
Moderate severity according to our Security Policy.
The FIPS modules in 3.5, 3.4, 3.3, 3.2, 3.1 and 3.0 are not affected by this
issue, as the CMS implementation is outside the OpenSSL FIPS module
boundary. |
